3Gen Partition Top Anchor PTA-PL - 100/Box

3Gen Partition Top Anchor PTA-PL

The 3Gen Partition Top Anchor PTA-PL is designed for top-of-wall masonry connections where partition walls need lateral restraint while still allowing movement from the slab or structure above. This masonry top anchor helps stabilize the wall without transferring compressive loads into the masonry below.

Used in commercial masonry construction, structural masonry applications, partition wall systems, and multi-story building assemblies, the PTA-PL is embedded in the mortar joint at the top of the wall. Its rod-and-tube design with expansion filler allows vertical slab movement while maintaining lateral shear resistance.

Hot dip galvanized after fabrication, this partition wall anchor provides corrosion resistance for long-term jobsite performance. It is a practical choice for contractors needing a code-compliant top wall anchor for brick, block, and masonry wall assemblies.

Features

• Provides lateral shear resistance at the top of masonry walls.
• Allows vertical slab movement above the wall.
• Helps prevent compressive loads from transferring into the wall below.
• Tube with expansion filler accommodates structural movement.
• Rod-and-tube design supports stable wall connections.
• Embedded in mortar joints for secure installation.
• Hot dip galvanized after fabrication for corrosion resistance.
• Designed for top-of-wall masonry connections.
• Suitable for partition wall systems.
• Used in commercial masonry construction.
• Built for multi-story building assemblies.
• Applicable for structural masonry wall applications.
• Helps maintain lateral wall stability.
• Works with brick and block masonry construction.
• Meets TMS 402/602 masonry code requirements.
• Meets ACI / ASCE 530 masonry code requirements.